Baracoda USB Plug & Play User Guide
• The scanner has been programmed from its default status and it is not able to decode the
Code 128 symbology. Be aware that the pairing barcode is a code128 and so the scanner
shall stay in its default mode “Code128 on”
3.3
How to pair your BCM2604-L/BCM2604-F
1. Reset the scanner by taking out and replacing both batteries.
2. If the scanner has not been programmed to read the Code 128 symbology, scan the Code 128 active
barcode (“Code 128 on”). The scanner should beep. The LED should remain a single flashing light.
Immediately reset the scanner. This will clear the memory buffer and allow the pairing barcode to
operate correctly.
Code 128 on
for the BCM2604-L FOR THE BCM2604-F
3. Plug the dongle into the USB port of the computer.
USB Plug & Play dongle. It is possible that the
5.
that pairs the scanner to the dongle.
4. Wait 5 seconds for the host computer to recognize the
host computer will not recognize the dongle: this can be corrected by going to the control panel
hardware wizard and searching for a USB HID device.
Do not scan any other barcodes except the barcode
read”
7. , the scanner will beep a second time: the LED on the scanner will start
8. d Word). Make sure the application can
9. ing barcodes. Please note that the USB Plug & Play is not able to transmit 2D barcodes
4 How to unpair your USB Plug & Play Dongle
6. Scan the pairing barcode and scan it just once (you will immediately get a “good
confirmation beep from the scanner. In case you don’t get an immediate double beep, simply reset
your scanner and try again).
Within less than 20 seconds
double flashing green: you are now paired and connected! *
Open up the target application (such as Notepad, Excel an
accept data from a keyboard and the active cursor is where the user wants the barcode information to
be placed.
Start scann
with an amount of information bigger than 1080 characters.
here are 3 different ways to unpair your USB Plug & Play dongle.
1. Reading the RESET barcode with the barcode scanner (after that connection has been
T
established). Use this barcode to unpair your barcode scanner from a USB Plug and Play dongle.
© Baracoda 2005
(2 Seiten)
(29 Seiten)
(11 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern